Two Wire LED adapters

[Giaka]

Hey I am not sure if any of you out there have a need for these adapters but thought I would throw this out there. My wife made up these adapters that allow you to use a 2 wire LED and run it at different intensities. Basically you could use a standard two wire side-marker (running light) and use it as a running light / turn signal or running light / brake light. She has them listed for sale at the URL below.

http://www.mikesshields.com/2wire.html

[Giaka]

By the way these are the units I installed on my side cases. I know they are very utilitarian looking but then again its a Versys.

http://www.superbrightleds.com/cgi-bin/store/index.cgi?action=DispPage&category=TRUCK&Page2Disp=/specs/msm.htm#photos

I would think most of the 2 wire LEDs from this page would work as well.

http://www.superbrightleds.com/cgi-bin/store/index.cgi?action=DispPage&Page2Disp=%2Ftruck_lights.htm

[TuffguyF4i]

Resistor and a diode with some shrink.  I've made those before.