Pages: 1 [2]  All   Go Down
Print

Topic: How to wear in-ear headphones  (Read 28572 times)

0 Members and 1 Guest are viewing this topic.
aviationfred
*

Reputation 10
Offline Offline

Motorcycles: 2008 VFR800, 2000 VFR800, 1996 VFR750 1990 FJ1200, 1990 VFR750
GPS: Wichita, Kansas
Miles Typed: 254

My Photo Gallery





Ignore
« Reply #20 on: August 29, 2015, 12:00:19 pm »


Ok, so...Plugfones. In short, not bad. They don't sound quite as good as the er6i, and they don't isolate noise quite as well. However, they're like $20, plus they have the virtue of actually being available to buy. I haven't had a chance to test the hours-on-end comfort level, but so far I'd give them a sold B+ for suitability-to-purpose, and A+ for value.

you can't go wrong in trying these as they're so cheap.


I had been using the MEE's and while not perfect, they worked well enough. Then I came across the Plugfones. I have ear canals that are on the smaller size so the foam inserts are too large and uncomfortable. The silicone barb inserts work perfectly and seal out ALL road noise and allow for music volume levels to be reduced without sacrificing sound listening quality.

I have ridden with the Plugfones on a few 6-8 hour rides, with multiple stops and they pull out and reinsert without any issues. The comfort is good. I got mine from eBay.

http://www.ebay.com/itm/Plugfones-Executive-New-and-Improved-Line-Ear-Plug-Earbuds-Headphones-with-Silic-/141679492467?hash=item20fcc17d73#ht_2364wt_1153

Fred
Logged

IBA #65004
Sport-Touring
Advertisement
*


Remove Advertisements

HipGnosis
It's Hip to Gno
*

Reputation 23
Offline Offline

Years Contributed: '10
Motorcycles: BMW F800ST(low), St Triple 765 R (low), Ninja 650
GPS: Not sure where I am, but I'm going back to villainy
Miles Typed: 5108

My Photo Gallery


Mercenary doppleganger scout




Ignore
« Reply #21 on: October 03, 2015, 10:31:31 pm »

Plugfones will be my next earbuds.
I'm going to find out if these 30 dB tips will fit them;  http://www.shop3m.com/3m-peltor-skull-screw-replacement-tips-370-1019-10.html  (available cheaper and/or smaller quantities from other vendors)
Or if I can make them fit.
Logged

“There's a time for daring and there's a time for caution, and a wise man understands which is called for.” - Robin Williams as John Keating in 'Dead Poets Society'
DrD
[eom]
*

Reputation 14
Offline Offline

Years Contributed: '08, '09, '10
Years Supported: '11
Motorcycles: '15 BMW S1000R
GPS: Reston, VA
Miles Typed: 1502

My Photo Gallery


Just passing by




Ignore
« Reply #22 on: November 20, 2015, 09:57:13 pm »


When I use in-ears phones I find the noise from the wires rubbing against anything (helmet edge, suit) extremely annoying. How do you avoid that?
Logged

Advertisement



RBEmerson
Repaired but not refurbed
*

Reputation 32
Offline Offline

Years Contributed: '07
Motorcycles: '17 FJR 1300ES, (lamented) '03 BMW K1200RS
GPS: Skippack, PA, USA
Miles Typed: 3748

My Photo Gallery


In Witness Relocation...




Ignore
« Reply #23 on: November 20, 2015, 11:56:43 pm »

Uh, change the phones for something with friendlier wires? I get the idea. Right now I'm wearing buds (Klipsch) and the cord's a bit annoying. The wires are a bit on thick, and stiff, side. OTOH, bump up the volume a bit or, on the road, bump the throttle a bit and notta problem.
Logged

It's taken me entirely too long to develop a sense of patience.
Pages: 1 [2]  All   Go Up
Print
Jump to:  



ST.N

Copyright © 2001 - 2013 Sport-Touring.Net.
All rights reserved.

 
SimplePortal 2.3.1 © 2008-2009, SimplePortal