Pages: [1]   Go Down
Print

Topic: Instaling Cruise Control in 2018 DL650  (Read 386 times)

0 Members and 1 Guest are viewing this topic.
Stormer
*

Reputation 14
Offline Offline

Motorcycles: 2019 BMW GS 1200 Adventure
GPS: Brazil
Miles Typed: 101

My Photo Gallery





Ignore
« on: February 26, 2019, 07:52:52 pm »

Hello guys,

Im trying to install the CCS100 cruise control in my 2018 DL650 Vstrom.

Followed the instructions, but system does not work.

Gone to the troubleshooting section of the installation manual and opened de cover on cruise and looked at the LED. Than:

a)      Press Set button, and LED LIGHET properly.  Seens ok, right?

b)      Press Resume button, and LED LIGHET properly. Seens ok, right?  But…

c)       Step on the brake, but LED DOES NOT lighted.  Seens something is NOT RIGHT, ok?

 Don’t know if somebody can help giving any tips to fix it.

Any help is very appreciated !!!!

Thanks a lot.
Logged

Sorry the bad English.
Sport-Touring
Advertisement
*


Remove Advertisements

Blue is Best
Light is right
*

Reputation 252
Offline Offline

Motorcycles: 2012 FJR1300 & 2016 Bandit 1250
GPS: Rio Rancho, NM
Miles Typed: 2356

My Photo Gallery


Blue motorcycles are fastest




Ignore
« Reply #1 on: February 26, 2019, 09:16:10 pm »

I have installed two on different bikes with no problem. I can't remember where the wires go but it is straight forward. Recheck all your wires and make sure they are connected to the proper signal source(brake lights, power and so forth). Then you have to make sure your "dip switches" in the brain are properly positioned up or down. Should work. Good luck.
Logged

Past bikes: Dirt- '74 MX360, SC500 x 2, '77 YZ400, '78 YZ400, '83 CR250, '85 CR250, '86 CR250   
 Street- '74 S3400, H1500, '72 H2750 x 2, '78 GS1000C, GS1000EC x 2, '80 GS1000S, '00 1200 Bandit, '05 FJR1300, '07 ZX14, '06 FJR1300(2 wks), '12 FJR1300
SLK50
Junior Member
*

Reputation 44
Offline Offline

Motorcycles: '06 FJR
GPS: Altoona, PA
Miles Typed: 1273

My Photo Gallery




Ignore
« Reply #2 on: February 26, 2019, 09:32:01 pm »

Do you have any extra lights wired into your
brake lights? Any LEDs ?
Many have found it necessary to wire a relay
into the brake light circuit to keep voltage
to CC at 0 volts till brakes are activated.
Logged
Pages: [1]   Go Up
Print
Jump to:  



ST.N

Copyright © 2001 - 2013 Sport-Touring.Net.
All rights reserved.

 
SimplePortal 2.3.1 © 2008-2009, SimplePortal